|2013 Street Stock Rules
|American Rear wheel drive only . Steel or aluminum stock style bodies. Spoilers 6” maximum, no
wider than deck lid.
WEIGHT WILL BE ADDED FOR ANYTHING THAT IS DEEMED RADICAL
Must look like car you are claiming. Stock frames. May build from firewall back (add 100lbs)
ROLL CAGE: Cage must have six points welded to frame. Minimum of three driver’s door Bars and
three bars in passenger’s door. Must have four windshield bars
SUSPENSION/STEERING: Stock Snout all Components must be in stock location. One (1)non
adjustable stock Type shock per wheel. May run after market upper control arm in original position.
Sliders & adjustable spring buckets or weight jacks OK. . Pan hard bar OK .Top link must Be solid.
No J-bars pull or lift bars .Remainder of suspension stock. May build frame firewall back
(add 100 lbs)
REAR END: Any O.E.M. Disc brake with steel calipers OK. Floaters Ok. Quick Change Ok -add
100lbs wide 5 ok w/QC
TRANSMISSION: Automatic or manual . Automatic must have working converter. No Bert or Brinn
No valve pedals. Manual must run stock type steel clutch and flywheel- 40lbs minimum.
Must have two inch hole in bell housing for inspection.
***Any other clutch adds 100 pounds
CARBURETOR:Any one (1) 4 BARRELL – 3100LBS.
Stock Holley 4412 500 cfm 2 barrel – 3000lbs. (May remove choke horn)
Gas or E85
IGNITION: Stock type, H.E.I. or point’s type.
WEIGHT: Minimum of 3000lbs
Any carb. Option add 100lbs – Quick change add 100lbs – Frame built behind firewall add 100lbs.
#3000: 8 inch wheels
#3000:602 Crate 8 to 10 Inch wheel
#3200: 10 or 12 inch wheel
Steel wheels only: may run wide five adaptor.
Bead locks recommended.
Any: Right rear must punch 50 or more at any time.
8 Inch tires are open: No punch rule.
ENGINE: Stock Location 1” TOLERANCE
steel 362c.i. max. no bowtie. MAY BALANCE, NO POLISHING anywhere.
Any oil pan, stock type pump, headers & bolts. No windage trays.
* 5.3 & 5.7 stock engines allowed with or without fuel injection*
HEADS: OEM or STOCK REPLACEMENT cast iron only. No modifications except cut for screw in
studs & guide plates. Valves No titanium . Any valve spring.
CAM: No roller or mushroom lifters.
PISTON: Flat top only,floating pin OK. piston cannot protrude above block deck
CRANK: stock OEM or stock replacement for block 49.5 lb min. NO crank scrapers.
RODS: stock type steel I beam only. Rods must be steel with Max of 6.00” in length.
Track retains 30 % of protest. You can only protest the car finishing one position ahead of you. $350
to pull one head. (cam, carb, intake, bore, & stroke) $400 for bottom rods,bore, & stroke) $50 per
visual tech retains all) CAR MAY BE IMPOUNDED FOR 2 days